A SERVICE OF

logo

10
Select an input signal.
Press the INPUT button on the remote control to select the input signal.
Or, press INPUT on the bottom of the set.
How to connect to two computers.
Connect the signal cables (HDMI-DVI and D-Sub) to each computer.
Press the INPUT button on the remote control to select the computer to use.
Directly connect to a grounded power outlet on the wall or a power bar with a ground wire.
Note
Connecting to External Devices
INPUT → → OK
Turn on the PC.
2.
Connect the power cord.
Rear back of the set
4
Turn on power by pressing the power button on the product.
1.
5
INPUT →◄ ► → AUTO/SET
When connecting with a D-Sub signal input cable.
• Select RGB : 15-pin D-Sub analog signal.
A.
Input List
AV Component RGB HDMI/DVI SuperSign
When connecting with a HDMI-DVI signal input cable and HDMI Signal Cable.
• Select HDMI/DVI : DVI Digital signal or HDMI Digital signal.
B.
Input List
AV Component RGB HDMI/DVI SuperSign
On/Off button
6