Laney
OPERATING INSTRUCTIONS
Page 19 /20
0V
H
1
0R
Laney
OPERATING INSTRUCTIONS
Supply Voltage ~100V, ~120V, ~220V, ~230V, ~240V 50/60Hz Factory Option
Mains Fuse (~220V>240V = T2A L 250V) (~100>120V = T5A L 250V)
HT Fuse T1A L
Power Consumption 300W
Output Power Rating 100W
Features Pure Class A/B Valve tone
4xEL34B-STR Power Tubes (Matched Set TAD)
6x12AX7 Preamp tubes (Premium TAD ECC83)
Hi & Lo Gain Inputs
Rugged construction
Selectable FX Loop with Level Control (Sidechain/Insert/Bypass, 500mV Nominal)
Individual Channel A+B FX loops (With Front panel controls, 500mV Nominal)
Line In/Line Out (Nominal)
EQ Passive Bass, Middle and Treble (Separate EQ For Clean and Drive)
Resonance Switch
Bright Switch (For Clean Channel+Clean Drive)
Presence
Footswitchable Channel, Drive A, Drive B, Reverb (Laney FS4 footswitch included)
Input Impedance 1MOhm/47pF
Size
Unit Weight 27.5Kg
Loudspeaker Outputs 1*16 Ohm
1*8 Ohm 2*16 Ohm
1*4 Ohm 2*8 Ohm
(H*W*D) 290*675*290
This product conforms to the requirements of the following European Regulations, Directives & Rules:-
CE Mark (93/68/EEC), Low Voltage (72/23/EEC), EMC (93/68/EEC),
RoHS (EU2002/95/EC), WEEE (EU2002/96/EC)
In order to reduce environmental damage, at the end of its useful life, this product must not be disposed of along with normal
household waste to landfill sites. It must be taken to an approved recycling centre according to the recommendations of the WEEE
(Waste Electrical and Electronic Equipment) directive applicable in your country.
SPECIFICATIONS
0V
H
1
0R
