Laney
1313
Specification
Model Output Power per Channel @ 1%THD Typical Total Power Consumption
Bridge Bridge
rd
2 Ohms 4 Ohms 8 Ohms 4 Ohms 8 Ohms @ 1/3 power music 4 Ohms
CA600 300W 200W 160W 600W 400W 220W
CA1500 750W 550W 350W 1500W 1000W 500W
CA3000 750W 550W 350W 1500W 1000W 1000W
x4 x4 x4 x2 x2
In bridge mode the amplifiers will operate comfortably at 4 Ohms enabling very high output levels to be achieved. This
together with very low output impedance gives exceptional power delivery into bass bin enclosures.
rd th
* (1/3 power is based on worst case severely compressed dance music. 1/8 power is average for normal minimally compressed music material just clipping on peaks)
Total Harmonic Distortion - All models typically less than 0.03% Across audio spectrum.
Intermodulation Distortion - All Models typically less than 0.03%
Input Sensitivity - User selectable, 0dB, +4dB and 26dB fixed.
Input Impedance - 15K ohms minimum
Damping Factor (8ohms) - Greater than 500 (minimum) with typical loudspeaker setups and cable.
Frequency Response - Flat across the entire audio spectrum (20Hz, 20Khz +- 0.5dBu), -1dB down at 10Hz and 25KHz
Hum and Noise - Better than -95dB ‘A’ Weighted
Input Connectors - One 1/4inch Jack socket and one 3pin XLR per channel
Output Connectors - One Speakon(TM) per output, One speakon(TM) per Bridge output.
Size(WxHxD) (mm) Weight (Kg)
CA600 483x88x320
CA1500 483x88x320
CA3000 483x88x435
Centre of gravity approx 160mm from front on all models.
Servicing
The CA series contains no user servicable parts.
Warning. Dangerous voltages may remain inside the unit for a short period after the amplifier has been turned off.
Do not operate with the covers removed.
Refer servicing to factory or qualified service engineer.
In the unlikely event of service being required, The amplifier should always be shipped in its original protective carton.
0dB
+4dB
26dB
0dB
+4dB
26dB
Before starting, Unplug all leads to the amplifier. Make sure mains supply is removed and switched off.
- Remove all screws from top cover, place to one side.
- Locate the input pcb that requires the gain changing. (Model shown pcb 9339, no VCA/limiter)
- Locate HD6 and HD1. Swap the jumper link as required.
- Refit cover.
Input Sensitivity
CA MANUAL
