Page 10 /12
Laney
SPECIFICATIONS
SPECIFICATIONS
Supply Voltage ~100V, ~120V, ~220V, ~230V, ~240V 50/60Hz Factory Option
Mains Fuse ~230V = T1A L. ~100-120V = T2A L (Time delay)
Power Consumption 100W
Output Power 65W
THD%N <0.03%
Microphone
Line In
CD In 22
Line In
Line In
Reverb Yes (Spring line, Remotely switchable)
Ext Loudspeaker Yes (Minimum impedance 8 ohms) (Internal left connected)
Internal loudspeaker 12” + High frequency horn
DI / Main out Yes (10dBu Nominal Level Balanced)
Headphone Socket Yes
Size 484*495*425 (H*W*D)
Unit weight 18.9 Kg
Packing weight 20.2 Kg
Channel 1 Inputs 2K input impedance, -30dBu Nominal input level
10K Input impedance, -15dBu nominal input level
Channel 2 Inputs K Input impedance, -10dBu nominal input level
10K Input impedance, -15dBu nominal input level
Channel 3 Inputs 10K Input impedance, -15dBu nominal input level
Channel 1 EQ Bass (±15dBu at 60 Hz) (Shelving)
Treble (±15dBu at 10 KHz) (Shelving)
Channel 2 + 3 EQ (Shared) Bass (±15dBu at 60 Hz) (Shelving)
Treble (±15dBu at 10 KHz) (Shelving)
This product conforms to:
European EMC directive(2004/108/EC), Low Voltage Directive (72/23/EEC) and CE mark Directive (93/68/EEC)
Page 11 /12
Laney
OPERATING INSTRUCTIONS
Line In
GAIN
Channel 1
VOLUME
D.I.
EQ SECTION
POWER
AMP
Channel 2
GAIN
Reverb
VOLUME
Remote
Line In
Mic
CD
BLOCK DIAGRAM
General Notes
Amplifier connection: In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off your
equipment. With all system parts connected, turn on source equipment, tape decks, cd players, mixers, effects processors etc.
BEFORE turning on your AUDIOHUB. Many products have large transient surges at turn on and off which can cause damage to
your speakers. By turning on your AUDIOHUB LAST and making sure its Volume control is set to minimum any transients from
other equipment will not reach your loudspeakers. Wait until all system parts have stabilised; usually a couple of seconds. Similarly
when turning off your system always turn down the Volume control on your AUDIOHUB and then turn off its power before
turning off other equipment.
Caution: These professional loudspeaker systems are capable of generating very high sound pressure levels. Use care with
placement and operation to avoid exposure to excessive levels that can cause permanent hearing damage. (Refer to guidelines on
page 2)
Servicing: The user should not attempt to service these products. Refer all servicing to qualified service personnel.
INTERNAL
LOUDSPEAKER
Headphones
EXT. SPEAKER
