Note: prior to drilling, make sure there are no cables or other pipelines behind the wall to
avoid damage. Remember that the screws on the wall should be fixed and firm to ensure
the safe installation of the heater on the wall. Please note the safe distance mentioned
below.
• During installation, the heater must be maintained a sufficiently safe distance from
combustible materials/gases and away from water.
• During wall-hanging installation, keep the installation height from the ground greater
than 15cm. The Hanging-type heater should be no less than 50cm away from the ceiling.
Operation Notice
• Make sure the heater shell, power cord and power plug are all intact.
• Check that the rated voltage on the model label on the heater matches that of the power
outlet being used: 230V, 50/60Hz.
Control Panel
To set the timer knob initially, please follow these instructions.
1. Check the time on your clock or watch. If it is 10:00, then turn the numbered timer disc
clockwise until the number 10 matches up to the “ ” on the timer. You can then set the
periods of time you want the heater to work by pushing the teeth inwards. Each “tooth”
corresponds to 15 minutes of functioning. You will then see visible sections that
correspond to periods of operation. When set, the heater will automatically operate each
day during the programmed time periods. (Note: for this to occur, the heater must be
plugged in to the power socket.)
2. To change the programming, move the teeth back into their initial position, then set the
new periods for functioning.
3. If you want to make the heater operate without programming, push all of the teeth into
the centre. While in this mode, turn the heater power off at the mains power supply to
avoid the continued operation of the timer.
Turn the temperature control knob clockwise to the end, then press the level-I power switch to
switch on low-level heating, or the level-II switch for high-level heating. If both levels are
switched on, the heater will be working at maximum power.
With the timer knob, you can set how many hours you want to pass before the heater starts up.
Simply turn the appliance on and select the required power and temperature. Then rotate the
timer knob clockwise until the pointer coincides with the number of hours you wish to set.
Once the set time has expired, the unit will start to warm up.
If you have any further questions or concerns, please contact the Kogan.com
customer support team.
3
Temperature
Control Knob
Timer Knob
