8
1 Plug the AC adapter cable into the jack
located on the rear of the charger.
2 Plug the AC adapter into an AC outlet.
3 Slide a battery pack or a transceiver
equipped with a battery pack into the
charging slot of the charger.
• Make sure the metal contacts of the
battery pack mate securely with the
charger terminals.
• The indicator lights red and
charging starts.
4 When charging is completed, the
indicator lights green. Remove the
battery pack or the transceiver from the
charging slot of the charger.
• It takes approximately 3 hours to
charge the battery pack.
• When the charger will not be used
for a long time, unplug the AC
adapter from the AC outlet.
CHARGING THE BATTERY PACK
ATTENTION: Always switch OFF a transceiver equipped with a
battery pack before inserting the transceiver into the charger.
Indicator
Charging
slot
Note:
◆ When the indicator blinks red, the battery pack is either defective or
the battery pack contacts are not properly mated with those of the
charger.
◆ The ambient temperature should be between 41°F and 104°F (5°C
and 40°C) while charging is in progress. Charging outside this range
may not fully charge the battery.
◆ The battery pack life is over when its operating time decreases even
though it is fully and correctly charged. Replace the battery pack.
