107
Troubleshooting
Receiver/Tuner
I’m getting a lot of static/interference.
• Check whether the receiver or antenna is too close to a TV or other
electrical appliance.
• Adjust the antenna for best reception.
• If you live in an area with weak FM signals, consider a rooftop FM
antenna (available at any home electronics store).
When I press a button to tune to a preset station, the receiver does
not respond.
Check whether:
• The receiver has been unplugged for more than three days. If it has,
your settings were cleared from the receiver’s memory. See “My re-
ceiver won’t turn on and the STANDBY indicator is flashing” on
page 104 of this manual.
• The Tuner input is selected. See “Tuner” on page 57 of this manual.
Macro is not running as I programmed.
• Because PowerTouch can only transmit one command at a time, stag-
ger the timings of the various macro settings so that the commands
are given at different times.
• On or Off command for audio devices may not work correctly if they
are not Kenwood components connected via system control cables.
• Depending on the video signals of the connected video devices, TV
power sensing may not work correctly.
