![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/6/8b/68b99663-30a6-43e1-962e-3e34198cb85f/68b99663-30a6-43e1-962e-3e34198cb85f-bg19.png)
English
|
25
In Standby mode
Switching preout
Alternating the preout between the rear and
subwoofer. (With the subwoofer the sound outputs
without being effected by fader control.)
Display Setting
"SWPRE R" Rear preout.
"SWPRE SW" Subwoofer preout.
In Standby mode
Built-in Amp Setting
Controlling the built-in amplifier.
Turning OFF this control enhances the preout
quality.
Display Setting
"AMP ON" The built-in amplifier activates.
"AMP OFF" The built-in amplifier deactivates.
News Bulletin with Timeout Setting
The tuner automatically changes when a news
bulletin starts even if the radio is not being listened
to. Also, you can set the time interval when
interruption is prohibited.
Display and Setting
"NEWS OFF"
"NEWS 00M"
…
"NEWS 90M"
When you set "NEWS 00M" — "NEWS 90M", the
News Bulletin Interrupt function is ON.
When the News Bulletin is ON, the "NEWS"
indicator is ON.
When the news bulletin starts, "NEWS " is displayed,
and the tuner changes to the news bulletin.
⁄
• If you choose the "20M" setting, further news bulletins
will not be received for 20 minutes once the first news
bulletin is received.
• The news bulletin volume is the same level that was set
for <Traffic Information> (page 13).
• This news bulletin function is only available if the desired
station sends PTY-code for news bulletin or belongs to
<Enhanced Other Network>-Network sending PTY-code
for news bulletin.
• When the News Bulletin Interrupt function is ON, the
tuner changes to an FM station.
In Audio file source
Supreme Setting
When AAC, MP3 or WMA files encoded at a low bit
rate (less than 96kbps (fs=44.1k, 48kHz)) are played,
this function restores their high frequency region
to approach the sound quality of equivalents of
these files encoded at a high bit rate. Processing is
optimized for the compression format used (AAC,
MP3, or WMA), and adjustment is made for the bit
rate used.
Display Setting
"SPRM ON" Plays sound using the Supreme function.
"SPRM OFF" Plays the original sound stored in the audio file.
⁄
• The sound effect may be imperceptible depending
on the relationship between the audio file format and
setting.
• This function is not available on iPod.