English
— 22 —
Disc source
? CD/MD play does not start.52
✔ CD/MD auto-changer input is not connected to the unit.
☞ Connect the CD/MD auto-changer input to the unit.
✔ Power button is not turned ON.53
☞ Turn the power button ON.
✔ The PROTOCOL selection switch of the changer switching unit "KCA-
S210A" is not set properly.54
☞ Set the PROTOCOL selection switch to "N" position.
? The specified disc does not play, but another one plays instead.52
✔ The specified CD is quite dirty.
☞ Clean the CD.
✔ The CD is upside-down.53
☞ Load the CD with the labeled side up.
✔ The disc is loaded in a different slot from that specified.54
☞ Eject the disc magazine and check the number for the specified
disc.
✔ The disc is severely scratched.55
☞ Try another disc instead.
? The specified track will not play.58
✔ Random play or magazine random play has been selected.
☞ Turn off random play or magazine random play.
? Cannot play CD-R or CD-RW.60
✔ Finalization processing is not being conducted for CD-R/CD-RW.
☞ Conduct finalization processing with CD recorder.
? Direct Track Search and Direct Disc Search can’t be done.66-1
✔ Another function is ON.
☞ Turn Random Play or other functions OFF.
? Track Search can't be done.66-2
✔ For the discs first or last song.
☞ For each disc, Track Search can't be done in the backward
direction for the first song or in the forward direction for the last
song.
? Sound skips due to vibration.67
✔ Something is touching the CD/MD auto-changer.
☞ Keep it away from the CD/MD auto-changer.
✔ The disc is dirty or damaged.68
☞ If sound skips at the same part, the disc is faulty. Check and, if
possible, clean the disc.
✔ Changer unit is mounted on the a slant.69
☞ Mount the unit so that is level.
✔ Changer unit is mounted in an unstable place.8
☞ Mount the unit in a stable place.
✔ The angle adjustment switches are set improperly.69
☞ Set the angle adjustment switches to the correct positions.
? Sound quality is poor.67
✔ The recording of the disc is poor.
☞ Try playing another disc. If the sound is good, the fault was with
the original disc.
✔ The disc is dirty or damaged.8
☞ Check and, if possible, clean the disc.
? No sound is heard even though the information concerning the
CD/MD auto-changer is displayed.67
✔ The radio volume is sets to the minimum level.
☞ Turn the radio volume up.
✔ The microcomputer does not function correctly.68
☞ Press the Reset button of the display unit. (Page 3)
✔ The system is not connected properly.69
☞ Connect the system properly. See <Connecting Wires to
Terminals>. (Page 18,19)
Troubleshooting Guide
KCA-R71FM_U.S_r3 04.7.8 3:58 PM Page 22
