58
11
4 Press [OK] to program the identified code in place of
the currently set code.
• The DCS function will be remained ON. You may press
[TONE] to switch the DCS function OFF.
• Press [ESC] if you do not want to program the identified
code.
• Press [SCAN] while the identified code is blinking, to
resume scanning.
Note: Received signals are audible while scanning is in progress.
DCS CODE ID
This function scans through all DCS codes to identify the
incoming DCS code on a received signal. You may find
it useful when you cannot recall the DCS code that the
other persons in your group are using.
1 Press
[TONE] to switch ON the DCS function.
• “DCS” appears when the DCS function is ON.
2 Press [F], [T.SEL].
• The current DCS code appears and blinks.
3 Press [SCAN] to activate the DCS CODE ID.
• “DCS SCAN” appears and blinks.
• Scan starts when signals are received.
• To reverse the scan direction, turn the Tuning control
clockwise (upward scan) or counterclockwise
(downward scan). You can also press Mic [UP]/ [DWN].
• To quit the function, press [ESC].
• When the DCS code is identified, the identified code
appears and blinks.
