13
42858-01 • 09/10/09 • Hunter Fan Company
8 • Completing Your Installation With a Bowl Light Fixture (continued)
8-12. Align the keyhole slots in the upper switch housing with the
housing assembly screws installed in Step 8-8.
8-13. Turn the lower switch housing clockwise until the housing as-
sembly screws installed in sub-steps 1 and 2 are rmly situated
in the narrow end of the keyhole slots. Tighten all four screws
rmly.
8-14. Partially install two of the screws into the lower switch housing
to mount the globe assembly.
8-15. Install candelabra-based light bulb, 60 Watt maximum.
8-16. Align the keyhole slots in the light kit with the screws installed
in the lower switch housing.
8-17. Turn the light kit clockwise until the screws installed are rmly
situated in the narrow end of the keyhole slots. Securely install
the third screw and tighten all screws.
CAUTION: Make sure the lower switch housing/light assembly is
securely attached to the switch housing mounting plate. Failure to
properly attach and tighten all four housing assembly screws could
result in the switch housing and light xture falling.
Step 8-13
Note: In compliance with US federal energy regulations, this
ceiling fan contains a device that restricts the light kit to a
maximum of 190 Watts. Exceeding that limit or the marked
limit on this product may result in re hazard or improper
operation.
