41569-01 5/24/2002 6 © 2002 HUNTER FAN CO.
that includes all mounting hardware and a fresh tube
of oil for this reason. The model number is 22360.
CAUTION: DO NOT TURN THE FAN ON UNTIL
LUBRICATION HAS BEEN ADDED. TO OPERATE
THE FAN WITHOUT OIL OR WITH LOW OIL WILL
VOID YOUR WARRANTY.
Canopy Installation
1. Assemble the canopy halves around the pipe.
Screw together loosely using the two canopy
screws provided in the sack parts.
NOTE: Brass and Antique Brass canopies are
shipped together.
2. Position the canopy close to the ceiling.
3. Tighten both of the assembly screws and
SCREW IN the canopy set screw. See Figure 14.
NOTE: If a Vaulted Ceiling Mounting Kit is used,
follow the canopy instructions provided with
the kit.
packaging has been provided to nest the parts
in during assembly to assure correct alignment
of parts.
NOTE: Grommets are usually assembled by
hand. If you use a tool, make certain you do
not damage the grommet or blade when in-
serting the grommets.
4. With some fans you have an option to install
four or five blades. For five blades, mount to
the outer row of holes on the motor. For four
blades use the inner row. See Figure 17.
5. To install the blades to the motor, insert the
blade iron screw through the hole in the blade
iron. Use a screwdriver to hold in place.
6. Fasten the screw onto the motor, but do not
overtighten. See Figure 18.
7. Line up the other hole on the motor and fasten
the second screw.
Figure 14
Set Screw
Assembly Screw
Step 7: Fan Blade Assembly and
Installation
WARNING: TO REDUCE THE RISK OF PERSONAL
INJURY, DO NOT BEND THE BLADE BRACKETS
WHEN INSTALLING THE BRACKETS, BALANCING
THE BLADES OR CLEANING THE FAN. DO NOT
INSERT FOREIGN OBJECTS IN BETWEEN
ROTATING FAN BLADES.
1. Attach the wood blades to the blade brackets
using three screws for each blade. See Figure 15.
Figure 15
2. If your blades have large holes, you must first
insert the rubber grommets into the holes. See
Figure 16.
3. Make sure that all screws are tight to prevent
vibration or wobbling. A cavity in the styrofoam
Grommet
Fan Blade
Figure 16
Figure 17
Outer Row
Inner Row
Figure 18
NOTE: Before tightening the screws, make sure
they are not cross-threaded in the mounting holes.
8. Tighten both screws securely. Repeat for the
remaining blades.
CAUTION: DO NOT ATTEMPT TO RUN THE FAN
UNTIL ALL SCREWS HAVE BEEN TIGHTENED
SECURELY.
9. A blade balancing kit has been provided with
your fan. Should the fan wobble in operation,
