19
Assembly
Testing Seat Clamp and Post Clamp Tightness
To test the tightness of the seat clamp and the post clamp:
WARNING: Every time the quick release mechanism is loosened, make sure
the red refl ector is correctly positioned as shown in fi g. 13 next page.
• Try to turn the seat side-to-side and to move the front of the seat up and down.
• If the Seat (14) moves in the Seat Clamp (fi g 10a):
• Loosen the Seat Clamp (A).
• Put the seat in the correct position and tighten the Seat Clamp tighter than
before.
• Do this test again, until the seat does not move in the Seat Clamp.
• If the Seat Post (33) moves in the Seat Tube (B):
• Move the Quick Release Lever (C) to the “open” position.
• Put the seat in the correct position and tighten the Quick Release Lever
tighter than before.
• If necessary, loosen Quick Release Lever , tighten Adjusting Nut (D) and re-
tighten Quick Release Lever .
• Do this test again, until the seat post does not move in the seat tube.
14
C
D
33
B
A
