••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
38
SECTION TWO
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
7. Push the paper length adjuster in toward the card stack until it
stops.
8. Replace the OUT tray. If you encounter difficulty replacing the
OUT tray, lift the top cover, wait a few moments for the print
cartridge cradles to move to the center position, replace the
OUT tray, then lower the top cover.
Make sure the cards do not bend in the IN tray.
9. Set the software to print on the size and type of cards now in the
printer.
Using Envelopes
The HP DeskJet 670C Series printer allows you to load up to 20
envelopes at a time in the IN tray or to feed a single envelope
through the printer (without first removing the paper from the
IN tray) by using the single envelope slot. When using the single
envelope slot, you can alternate printing on an envelope then on
a piece of paper. This feature is useful when printing a series of
letters and their corresponding envelopes.
N OTE
Using loosely creased or thick envelopes reduces the capacity of the IN tray.
Because of these variations in envelope styles, the IN tray might accommodate
less than 20 envelopes.
Always use envelopes that conform in weight, type, and size
with those listed in the Specifications on page 70.
2162028
Paper Length
Adjuster with
Handle Released
