A SERVICE OF

logo

EN
Getting Started Guide 21
Connecting to Ethernet 10Base2 Network
Use the BNC port to connect the printer to an Ethernet 10Base2
network.
Caution
Make sure the printer is turned off before connecting to the BNC
port.
Attach one section of your ThinLAN cable to the BNC “T
connector.
Attach another ThinLAN cable section or a 50-ohm terminator to
the other side of the BNC “T
connector. If you are attaching the
printer to the end of your network you must connect a 50-ohm
terminator.
Connect the BNC “T
” to the BNC port.
Note
The 10Base-T port is the default port on the HP JetDirect 600N print
server card.
Note
The HP JetDirect 600N print server card supports one Ethernet
cabling connection at a time.