12 Getting Started Guide
EN
Step 7. Load Trays
Tray 2
Tray 2 is a 500-sheet tray. It adjusts for
letter, A4, and legal sizes.
1
Pull the tray completely out of the
printer.
2
If the tray is not already set to the
desired paper size, snap the left and
right guides into place to match the
width of the paper. For A4 size
paper, slide the lock down to secure
the guide.
3
Lift the back of the rear paper guide
and slide it to the desired paper size
until it clicks into place. If the tray is
not properly adjusted, the printer
might display an error message or
paper might jam.
4
Load paper into the tray.
5
Make sure the paper is flat in the tray
at all four corners and below the tabs
on the guides. Gently slide the tray
back into the printer.
The printer automatically senses the
size of paper if the tray is adjusted
correctly.
Lock
