Re-install screws removed in step
above and loosely attach aligning
all three materials.
Note: An awe or scribe is
recommended to help align holes
Item #9 to #5
Place 3
rd
compartment bench
Photo shows optional storage door
Note: Be careful not to scratch bulkheads.
Item #10
Bolt 3
rd
Compartment Bench to 3
rd
Compartment Divider using ¼” x ¾”
carriage bolts and serrated nuts. Nuts should
be on the inside of the bench
Item #10 to #9
Position 3
r
compartment ceiling and loosely attach a few
¼” x ¾” hex head bolts and washers where 3
rd
compartment divider and ceiling meet with rear passenger-
side ceiling. This is the most difficult section to install due
to aligning all 3 materials. Be sure to do this step prior to
attaching any part of ceilings or 3
rd
compartment divider.
VERY IMPORTANT!!!
Items #9, #8, & #12 all bolt together
Items #9, #8, #12
Item #9 to #2
Item #9 to #2
Loosely bolt Passenger-side Bench/Wall assembly to 3
rd
Compartment Bulkhead using ¼” x ¾” Carriage bolts and
serrated nuts
Note: An awe or scribe is recommended to help align holes.
Bolt 3
rd
Compartment Divider to
Passenger side Wall using ¼” x ¾”
carriage bolts, washers and nuts.
KK-XXX-05_INST_8-07
13
