16
29
• Install the battery into the battery compartment (see step
2, page 19 in the Battery Installation section).
• Plug the battery harness and the motor harness together.
Push firmly to snap the connectors together.
30
• Test to be sure you have assembled the power button
harness correctly.
• Press the power button. The vehicle should move forward.
• If the vehicle does not move, you have probably assem-
bled the power button harness incorrectly. Please re-read
assembly steps 1-7 and 24-25.
31
• Fit a handgrip on the end of each handlebar.
Hint: If it is difficult to slide the handgrips onto the handle-
bars, moisten the inside of the handgrips with water.
32
• Fit the tab on the seat into the slot in the gas tank.
• Using a slotted screwdriver, turn the lock fastener
1
/
4
turn
to the locked position .
IMPORTANT! Remember to keep the lock fastener
locked at all times to prevent children from accessing
the vehicle battery.
Assembly
Power Button
Handgrip
Handgrip
Handlebars
Seat
Tab
Gas Tank
Lock Fastener
Lock Fastener
LOCKED
UNLOCKED
