Always use a low spindle speed when
machining non-cylindrical or off-center
workpieces to avoid ejecting the workpiece
from the holding device at a high rate of
speed. Failure to heed this warning could
lead to serious personal injury or property
damage.
Using the Faceplate
To mount a workpiece on the faceplate:
1.
2.
3.
Figure 30
Note: Take into account the rotation and
cutting forces that will be applied to the
workpiece when clamping it to the faceplate.
Figure 30.
Centers
Figure 31
Figure 31.
Tailstock Page 27
Installing a Sleeve and Center into
the Spindle
1.
2.
