Figure 32.
4.
5.
Note: Make sure the drawbar is threaded into
the tool a minimum of five to 10 turns.
6.
Note: Over-tightening the drawbar could
make removing the tool difficult, so only snug
the drawbar in place.
7.
Unloading Tooling
1.
2.
Loading/Unloading
To o li ng
Figure 31
Tools Needed Qty
Loading Tooling
1.
2.
3.
Figure 32
Cutting tools are sharp and can quick-
ly injure your hands. Always protect your
hands when handling cutting tools.
Figure 31.
Chip Characteristics
