-34-
G0632 16" x 42" Variable Speed Wood Lathe
SECTION 5: ACCESSORIES
ACCESSORIES
G1194—3-Jaw Chuck
A "must have" for the serious wood turner. This
3-jaw chuck is a self-centering style chuck used
mostly for round work. All three jaws tighten
together at the same time. Jaws are reversible for
expanded work holding capacity. Threaded insert
required for mounting!
Figure 48. Model G1194 3-Jaw Chuck.
G1082—4-Jaw Chuck
Another "must have" for the serious wood turner.
This 4-jaw chuck is an independent type chuck
that is used for square and odd-shaped pieces.
Each jaw tightens individually and can be turned
around to hold larger dimension workpieces.
Threaded insert required for mounting!
Figure 49. Model G1082 4-Jaw Chuck.
H9586—Lathe Fundamentals
With more than 300 color photos, this fourth
authoritative Popular Mechanics Workshop tool
book helps woodworkers take full advantage of
this most essential piece of equipment. No guide
will give them a better start. 192 pages.
Figure 50. Model H9586 Lathe Fundamentals
guide book.
Figure 51. Robert Sorby Stebcentre.
H5954—Robert Sorby Stebcentre MT#2
Razor sharp teeth bite into the workpiece for
secure operation and the spring loaded center
point controls the amount of drive or slip. This pat
-
ented feature helps avoid the problem of ‘dig-in’.
Production turners can also load and unload their
work while the lathe is still running
!
G3167—1
1
⁄4" x 8 TPI RH Threaded Insert
This threaded insert is required to mount a 3- or
4-jaw chuck to your wood lathe.
