6
3
2. Press a Small Plastic Cap (31) into the Center
Base (7). Attach the Eyebolt (17) to the Center
Base with an M10 Nylon Locknut (23) and two
M10 Washers (21) as shown.
Attach the Center Base (7) to the Left and Right
Bases (5, 6) with the four M10 x 65mm Bolts
(20), four M10 Washers (21), and four M10
Nylon Locknuts (23). Do not tighten the Nylon
Locknuts yet.
3. Hold the Left and Right Braces (3, 4) against the
Lower Frame (2) and the Left and Right Bases
(5, 6). Attach the Braces to the Lower Frame with
two M10 x 70mm Bolts (18) and two M10 Nylon
Locknuts (23). Do not tighten the Nylon
Locknuts yet.
Tip the Lower Frame (2) and attach the Braces
(3, 4) to the Bases (5, 6) with the two M10 x
63mm Carriage Bolts (27) and two M10 Nylon
Locknuts (23).
Tighten all of the M10 Nylon Locknuts (23)
used in steps 1, 2, and 3.
2
3
4
18
23
23
23
27
27
5
6
4. See the inset drawing. Press the Large Plastic
Cap (15) into the top of the Upper Frame (1).
Hold one of the Large Plates (11) inside of the
Lower Frame (2) as shown. Insert two M10 x
15mm Screws (16) with M10 Washers (21) into
the right side of the Lower Frame and finger
tighten them into the Large Plate. Attach the
other Large Plate (11) inside of the Lower Frame
in the same way.
Slide the Upper Frame (1) onto the two Large
Plates (11). Insert four M10 x 15mm Screws (16)
with M10 Washers (21) into the Upper Frame
and finger tighten them into the Large Plates.
Tighten all eight M10 x 15mm Screws (16).
4
11
11
21
21
1
15
1
16
16
21
21
16
16
20
21
21
21
21
21
21
20
23
23
7
17
5
6
23
31
2
2
