5
SENDER PANEL DESCRIPTIONS
5V DC Power Input1
Connect the included 5V DC power supply input this port. Once this has been
properly connected the power LED will become active.
3 RCA Component Input2
Connect the component source device to this input.
2 RCA Analog Stereo Input3
Connect the source’s analog audio to this input.
SPDIF Digital Audio Input4
Connect the source’s SPDIF digital audio to this input.
Optical Digital Audio Input5
Connect the source’s optical digital audio to this input.
Power LED Indicator6
This LED will become active once the included 5V DC power supply is properly
connected.
RJ-45 Jack7
Connect the sending and receiving units together using a TIA/EIA-568-B
terminated CAT-5, CAT-5e or CAT-6 cable. See page 10.
NOTE: Only one audio input type, digital or analog, should be connected at one time.
