INSTALLATION
~QUImMENTS
WORTANT..
.Please
Read
CarefuUy.
How to connect electricity
For personal safety, this appliance must be properly grounded.
The power cord of this appliance is equipped with
a three-prong (grounding) plug which mates with a
standard three-prong (grounding) wall outlet (Fig. 1)
to minimize the possibility of electric shock hazard
from this appliance.
Fig. 1
INSURE PROPER GROUND
EXISTS BEFORE USE
Have wall outlet and circuit checked by a qualified
electrician to make sure outlet is properly grounded.
Where a standard two-prong wall outlet is
encountered, it is your personal responsibility and
obligation to have it replaced with a properly
grounded three-prong wall outlet.
DO NOT, UNDER ANY CIRCUMSTANCES,
CUT OR REMOVE THE
T~RD
(GROUND)
PRONG FROM THE POWER
CO~.
DO NOT USE AN ADAPTER PLUG TO
CONNECT THE REFRIGERATOR TO A
TWO-PRONG OUTLET.
DO NOT USE AN EXTENSION CORD WITH
THIS APPLIANCE.
The refrigerator should always be plugged into
its own individual electrical outlet—(] 15 volt, 60
Hertz, single phase AC—protected by a 20-amp time
delay fuse or circuit breaker). This is recommended
for best performance and to prevent overloading
house wiring circuits, which could cause a fire
hazard from overheating wires.
IMPORTANT: The water line and the electrical
outlet must be installed in the exact location described
in the Installation Instructions (Pub. No. 49-6445).
PmPAWTION
Refrigerator Location
Clearances
Install the refrigerator on a floor strong enough to
If the refrigerator is to be installed in a corner, allow
support it when it is fully loaded.
2“ between the hinges of the refrigerator and the wall
Do not install refrigerator where temperature will
to assure a 90° door opening capability.
go below
60°F.
because it will not run often enough
No other clearances at top, sides or back are required.
to maintain proper temperatures.
Leveling
This model has 4-point leveling. All four corners are
supported by leveling legs. The front wheels are non-
adjustable; they are only used for positioning the unit.
● To level the back of the unit, turn hex nut located
above the front wheels.
● To level the front of the unit, use a 1
Y4°
open end
wrench and adjust the leveling legs.
● Turn hex nut or front leveling leg clockwise to raise
the unit, counter-clockwise to lower the unit.
See the Installation Instructions (Pub. No. 49-6445)
for complete directions.
4
17
