I
! PROBLIGY1
\ WATER WON’T
~ DRAIN
t
~ WATER LEAKS
~ WASHER IS NOISY
I
i
!
I
I
~ WASI-IER PAUSES
~ IN CYCLE
4
● Make sure drain hose is not kinked.
● Top of drain outlet should be less than 8 ft. above tloor.
● iMake sure hose connections are tight at faucets.
@Make sure end of drain hose is correctly inserted in and secured to drain facility.
● Make sure washer is level and firm to the ~loor with rubber foot pads in place and
front jam nuts tight. See your Installation Instructions.
● A sharp distinctive sound will be heard at the end of each spin period as the motor
stops and the spin brake inside the transmission “locks in:’ This sound is normal.
* Heavily unbalanced loads can cause the washer to vibrate excessively during spin,
and may cause it to move from its original position. In extreme cases, (usually occurs
when washing a single, heavy item or a small load when water level is set higher than
necessary) the spin basket may strike the outer tub, creating a loud but harmless noise.
To correct, open the iid and redistribute the load evenly about the wash basket. Close
the iid and restart.
● Washer normally pauses between washing steps. .
.such as between wash and spin or
between spin and rinse.
H’ you need more help . ..call, toil free:
GE Answer
Center@
800.626.2000
consumer information service
... .
