Tm
PROBLEM
SOLmR
(continued)
PROBLEM
SNAGS, HOLES,
~ARS,
~S
OR
EXCESSI~
WAR
(continued)
WASHER WON’T
OPEW~
WA~R
WA~R
WON’T
D~
POSSIBLE CAUSE
●
Chemicals
such as hair bleach, dye, permanent wave solutions, battery
acids
and
toflet
bowl
cleaners may cause fabric holes.
Rinse
~1
towels and
otier
articles that
came in contact with these chemicals before putting them in wash. Do not
contaminate clothing articles with these chemicals.
c
As permanent
press garments age, they
may
show
fraying at
co~ars
and cuffs. This
is normal due to
weaketig
of fibers by the permanent press process. It is not caused
by washer. You can slow this process by washing small permanent press
loads
with
a large water level. Do not wash heavy
items
such as towels with permanent press.
Remove collar stays, when
~ssible.
●
May be caused by the use of Regular Cycles for delicate articles. Use Permanent
Press cycle. Refer to garment manufacturer’s care labels.
●
Garments weakened by age, sun or atmosphere. This is inevitable and is not caused
by washer.
●
Over loading or under loading washer for selected water level. Load washer only with
number
of items that will move freely. Select correct water level.
Pretreat
with liquid detergent. See Other Laundry Products section.
@@@@
●
M*e
sure
cord
is
plugged into outlet.
●
Make sure both hot and cold faucets are turned on.
●
Make sure controls are set and Cycle Selector knob is pulled out to
ON
position.
●
Make sure lid is closed. Washer
wi~
fill but will not spin or agitate with
tid
open.
*
Check
house fuses or circuit breakers.
M
another appliance is sharing the electrical
outlet, remove it. Washer should have separate outlet.
*
Make
sure temperature selector controls are
correetly
set.
~
*
M&e sure hot and cold faucets are turned on and
regulated correctly.
s
Make sure hoses are connected to correct faucets...
hot to hot, cold to cold.
(+)
${
*
Water valve
s~reens
may be stopped up. Remove inlet
hoses
from
water
valve. Clean
the
screens and reinstall hoses.
●
Check
house
water
heater
to make sure it is delivering water at
120°F.-1500F.
(45°C.-650C.).
*
Make
sure drain hose is not kinked.
*
Top of
draia
outlet
should
be
less
than 8
ft.
{2.4
m)
above floor.
18
