How to Use the Soak Cycle
● Soak: Turn the Cycle Selector knob to soak. Start
the washer. Add pre-measured detergent or soak
product; add clothes.
● NOTE: For an extended soak, allow the washer
to fill and agitate for a few minutes to dissolve the
soaking agent. Then push in the Cycle Selector knob
to stop the washer (keep lid closed) and allow to
soak for as long as desired. After desired soak
period, pull out the Cycle Selector knob to complete
the cycle.
“
Do not use the Fabric Softener Dispenser or the
Mini-Basket tub with the Soak cycle.
ENERGY-SAVING
T~S
If your clothes and household items don’t look clean
of the rinse does not affect cleaning.
and fresh after washing, you will probably rewash
them.. and that means you’ll waste energy.
●
Wash in off-peak utility hours. Your local utility
Remember to sort your clothes carefully, and load
can tell you which are the off-peak hours.
them properly, select correct cycles, use enough
● Use your washer’s Normal Spin. This will remove
detergent and choose a water temperature warm
more water during spin, which
will
shorten drying
enough to release and
get
rid of soil.
cycle to save more energy.
.,
● Try to wash less often. Save articles of the same
● Use your Mini-Basket tub for very small loads. It
type of fabric until you have a full load.
uses less water than the
tub on this washer. You
c
If you must wash smaller loads, adjust the amount
of water. Small loads should have lower water levels.
and energy.
small
wa~er
level in the big
will also save on detergent
● Always rinse in cold water. The temperature
9
