How to use the
Soak setting
v
● “SOAK” setting temperature
will automatically be cold.
● If a hot or warm soak is desirul, set
the WNH~SE TEMPERATURE
switch to “1+~/COLD” or
“WARM/COLD” and turn the
Cycle Selector Knob to “Normal”
in the Regular Cycle. Start the
washer. After washer fills and
begins to agitate, push in the Cycle
Selector Knob and turn to “SOAK7
Pull out the Cycle Selector Knob
to complete the cycle.
How to use the
Filter-l?lo”I%n
1
● For an extended soak, allow the
washer to fill and
agMe for a few
minutes to dissolve the soaking
agent. Then push in the Cycle
Selector Knob to stop the washer
(keep lid closed) and allow
to soak
for as long as desired. After desired
soak period, pull out the Cycle
Selector Knob to complete the
cycle.
The Filter-Flo pan is the lint filter.
Position the Filter-Flo pan on the
agitator stir loading clothes into
the washer. Lint is easily seen and
removed after the wash is finished.
N(YTE: Do not use the Filter-Flo
pan as a wash basket. Do not put
any items to be washed in the
Filter-Flo pan.
Energy-Saving Tips
If your clothes and household items
don’t look clean and fresh after
washing, you will probably re-wash
them.. and that means you’ll waste
energy. Remember to sort your
clothes carefully, and load them
properly, select correct cycles, use
enough detergent and choose a
water temperature warm enough to
release and get rid of soil.
● Use Hot Wash—up to lSO°F.-on
a regular basis only when washing
heavily soiled articles-such as
work and play clothes.
. Under normal soil conditions,
wash in water above 80°F. (Z7°C.).
This generally means using the
Warm Wash temperature setting on
your washer—temperatures
approximate y 90° to llO°F. or hand
comfortable. If you notice that soil
has accumulated after several
con~tive washings, use Hot Wmh
occasionally, if safe for fabrics.
● Try to wash less often. Save
articles of the same type of fabric
until you have a fill load.
● If you must wash smaller loads,
adjust the amount of water. Small
loads should have lower water
levels.
Q Wash in off-peak utility hours.
Your local utility can tell you which
are the off-peak hours.
8
