OPERATmG
~STRUCTIONS
(continued)
How to Soak in Your Washer
Allow
the washer to fill and agitate for a few minutes to dissolve the
soaking agent. Then push in the
Cycle
Selector knob to stop the washer
(keep
lid
closed) and allow to soak for as long as desired.
After desired soak period, pull out Cycle Selector knob to complete cycle.
How to Use the Filter-Flo Pan
The Filter-Flo pan is the lint
NOTE: Do not use the Filter-Flo pan as a wash
filter. Position the Filter-Flo .
pan on the agitator after
loading clothes into
the washer. Lint is
easily seen and removed
o
basket. Do not put items to be washed in the
g
..~~.
,~.
i.!;
. . . . ..
.
‘:::”
c,
::,;:i:>
:.
Filter-Flo pan. Do not place detergent packets
,::::;j;:
~~
,<::,.;,<,;,:,:..
.:i!:::!,:!:,
in the Filter-Flo pan.
after the wash is finished.
ENERGY-SAVING
TWS
If your clothes and household items don’t look clean
● Always rinse in cold water. The temperature
and fresh after washing, you
will
probably rewash
of the rinse does not affect cleaning.
them.. and that means you’ll waste energy.
Remember to sort your clothes carefully, and load
●
Wash in off-peak utility hours. Your local utility
them properly, select correct cycles, use enough
can
tell
you which are the off-peak hours.
detergent and
~hoose”
u water temperature warm
● Use your washer’s Normal Spin. This will remove
e~xough
t{)
release and get rid
c)j’.vc)il.
more water during spin, which will shorten drying
● Try to wash less often. Save articles of the same
cycle to save more energy.
type of fabric until you have a full load.
● If you must wash smaller loads, adjust the amount
of water. Small loads should have lower water levels.
6
