Wash Water Temperature Selection
● For hot water wash, set Cycle Selector
to HOT WASH.
● For cold water wash, set Cycle Selector
to COLD WASH .
RINSE WATER TEMPERATURE WILL
ALWAYS BE COLD.
Starting or Choosing the Cycle
● Pull Cycle Selector knob out to start the cycle.
If you wish to change cycle setting
after
washer
has
+
START ,
started, push Cycle Selector knob in to stop washer
and reset to the new position. Setting can be changed
at any time during the cycle.
9
,,
. \
STOP
~
How to Soak
in
Your Washer
Allow the washer to fill and agitate for
a
few minutes to dissolve the
soaking agent. Then push in the Cycle Selector knob to stop the washer
(keep lid closed) and
allow
to soak for as long
as
desired.
After desired soak period, pull out Cycle Selector knob to complete cycle.
ENERGY-SAVING
TWS
If your clothes and household items don’t look clean
● If you notice that soil has accumulated after several
and fresh after washing, you will probably rewash
consecutive washings, use Hot Wash occasionally, if
them... and that means you’ll waste energy. Remember
safe for fabrics.
to sort your clothes carefully, load them properly, and
use enough detergent.
● Try to wash less often. Save articles of the same type
of fabric
until
you have a full load.
●
Wash in off-peak utility hours. Your local utility can
tell you which are the off-peak hours.
What Happens in Each Setting (Approximate Minutes)
Cycle
Hot Wash Cold Wash
NOTES:
Wash
3
● Total time includes pauses between each
phuse
of
the
cycle.
Wash
8
8
●
Tottil
time dries
t?ot
include water fill times. Fill times
Spin
3’1?
3’1?
vary depending
on
household
water pressure and
yc>ur
Rinse
2’/2
2’/?
selected water level.
Spin
6
6
Total Time
25
22
5
