STEP 6 – REMOVE TOEKICK BRACE
Skip this step if your model does not have a sound upgrade
kit. If your model does have a sound upgrade kit, this brace
• Remove the 2 toekick brace
STEP 4 – REMOVE WOOD BASE,
– Do not kick off wood base! Damage
• Move the dishwasher close to the installation location and lay
• Remove the four leveling legs on the underside of the wood
base with an adjustable wrench or 15/16" socket.
• Screw leveling legs back into the dishwasher frame
approximately 1/8" from frame as shown.
• Remove the 2 toekick screws
06C-1683A
White
Ground
Black
STEP 7 – INSTALL POWER CORD
Skip this step if dishwasher will be permanently connected
to the house electrical system.
In this step you will need the junction box cover and the
#10 x 1/2" hex head screw from the screw kit set aside in
The power cord and connections must comply with the
National Electrical Code, Section 422 and/or local codes and
ordinances. Maximum power cord length is 6 feet. Power Cord
Kit WX09X70910, available for purchase from an authorized GE
Appliance Dealer, meets these requirements.
• Install strain relief in junction box bracket.
• Insert power cord through strain relief and tighten.
• Make sure black, white and green dishwasher wires are
threaded through small hole in junction box bracket.
• Connect like colored dishwasher and power cord wires. If
power cord wires are not color coded, connect the ribbed
power cord wire to the white dishwasher wire, the smooth
power cord wire to the black dishwasher wire and the ground
to the green dishwasher wire. Use UL listed wire nuts of
• Install junction box cover set aside in Step 1, using #10 hex
head screw. Be sure wires are not pinched under the cover.
05A-1183A
Remove 2
Toekick Screws
