Safety InformationOperating InstructionsTroubleshooting TipsCustomer Service
About the display diagnostic codes.
12
Display What It Means What To Do
Electrical power to the
IF DISHWASHER WAS IN USE WHEN
dishwasher has been
THE POWER FAILURE OCCURRED:
RESET
interrupted but is now
back on.
1
Press the
RESET
pad and wait
approximately 30 seconds.
2
Unlatch and open the door.
A
If the detergent cup is open and
empty and the dishwasher was set
for the
NORMAL, POTS PANS
or
CHINA CRYSTAL
cycle, close
door and put the load through a
RINSE HOLD
cycle. After the
RINSE HOLD
cycle is completed,
add detergent and reset the load
for the washing cycle you want.
B
If the detergent cup is closed and
the dishwasher was set for the
NORMAL, POTS PANS
or
CHINA CRYSTAL
cycle, reset the
dishwasher for the wash cycle
you want
.
C
If the dishwasher was set for the
RINSE HOLD
cycle, reset the
dishwasher for
RINSE HOLD.
IF THE DISHWASHER WAS NOT IN USE
when power failure occurred, use
dishwasher as you normally would.
Slow draining. The This dishwasher is designed to
dishwasher is taking automatically compensate for longer
longer than normal to than normal drain times, but cycle time
drain the water out. will be extended. If this code continues
This is usually caused to appear frequently:
by a blockage in the drain
air gap, a kink in the
drain hose, or a
stopped-up pipe.
1
Clean the air gap.
2
Check for a kink in the drain hose.
3
Check plumbing for slow or
stopped-up drains.
NOTE:
Warranty service does not
cover household drain problems.
