CHAPTER 9 Configuration and Status Checking (Contents, Methods, and Procedures)
9.2 MMB CLI
170
Reference sections in the PRIMEQUEST 2000
Series
Tool Reference (C122-E177EN)
1.3.5 [Reserved SB Configuration] window
The video redirection for each IPv4/IPv6 is set.
1.3.6 [Console Redirection Setup] window
Power Limiting of each partition is set.
1.3.7 [Power Management Setup] window
Displays the partition status and various information
related to the partition.
Sets conditions for automatically restarting the partition
(ASR (Automatic Server Restart) Control).
Starts video redirection.
Sets various modes for the partition.
Displays information on the currently registered user
account.
Changes the password of the currently logged-in user.
1.4.2 [Change Password] window
Displays a list of users connected to the MMB via
Serial, Telnet/SSH, and Web-UI.
Sets the MMB date and time.
Sets the IP address and other values for MMB access.
1.5.2 [Network Interface] menu
Sets Speed/Duplex of each port on the MMB board.
1.5.3 [Management LAN Port Configuration]
window
Sets the network protocol of the MMB.
1.5.4 [Network Protocols] window
Configures automatic update for Web-UI windows
whose status changes.
1.5.5 [Refresh Rate] window
Makes settings related to SNMP.
1.5.6 [SNMP Configuration] menu
Sets an SNMP trap destination.
1.5.6 [SNMP Configuration] menu
Sets the Engine ID and makes user settings specific to
SNMP v3.
1.5.6 [SNMP Configuration] menu
Creates a secret key and the corresponding CSR
(signature request).
Retrieves the secret key or CSR (signature request)
stored on the MMB.
Imports the signed electronic certificate sent from the
certificate authority to the MMB.
Creates a self-signed certificate.
Creates a private key for the SSH server.
Makes the user settings required for control of the
MMB via RMCP from the remote server.
1.5.9 [Remote Server Management] window
Operates access control for network protocols.
1.5.10 [Access Control] window
Sets e-mail notification for when an event occurs.
1.5.11 [Alarm E-Mail] window
Executes the batch firmware update process.
1.6.1 [Firmware Update] menu
Backs up and restores MMB/UEFI configuration
information.
1.6.2 [Backup/Restore Configuration] menu
Provides support in the form of a wizard for device
maintenance.
1.6.3 [Maintenance Wizard] window
Operates REMCS and makes settings related to
REMCS.
9.2 MMB CLI
You can access the MMB CLI via the MMB serial port or the management LAN. The commands that you can
use from the MMB CLI include those for display and settings.
For details on MMB command lines, see Chapter 2 MMB CLI (Command Line Interface) Operations in the
PRIMEQUEST 2000 Series Tool Reference (C122-E177EN).
For details on functions provided by the MMB CLI, see the reference sections in the PRIMEQUEST 2000
Series Tool Reference (C122-E177EN).
