Titan models
The Flip top wok support goes in the centre
over the wok burner. The other two pan
supports are interchangeable but need to be
rotated to match the rounded corners of the
base insert.
Jet models
The pan supports above the wok burner are
different from the other burners. Note the
raised area for the wok on the pan support.
Repositioning the pan supports
Correct pan support orientation - Titan models
Rounded corners
Re-assembling your wok burner (CG901M Iridium models only)
Each part of your wok burner has locating pins to help you to assemble it correctly after
cleaning. Incorrect assembly can cause dangerous irregular flames and ignition problems.
Refer to this diagram for the correct order of assembly. Note: The brass parts of your wok
burner will change colour with use. This is normal and will not affect performance.
Rotate vent ring to align locator
pin with hole in burner base.
Inner cap
Outer cap (small holes)
Trim ring
Vent ring with locator pins
(large holes)
Align and insert pin
Side view
raised area on wok support
Correct pan support orientation - Jet models
8 9
