40
Delete All Cards
All cards can be deleted at once. At the following window:
Press
and system will prompt the user to confirm deletion:
Press
again to delete all cards.
Caution: this operation will permanently delete ALL cards from the controller
database.
Set Card Properties
Under the Card Setting menu, press
twice to bring up the following window:
Press
and system will prompt the user to enter serial number, as shown below:
After entering the serial number, press
to enter the submenu for setting card
properties. Each card has 6 properties that can be modified. Use
and
to
choose desired properties.
Status Setting
A card can be set as enabled or disabled at the following submenu:
Press
and system will show the status of current card as the figure below. Press
to toggle between the two statuses. Press to exit without effecting any
change.
Card Enabled
[ENT] to Toggle
Card Disabled
[ENT] to Toggle
Delete All Cards
Are You Sure ?
[ENT] to Confirm
Set Card
Properties
Card Serial #:
________
Status Setting
CLR
