A SERVICE OF

logo

-- 9 --cmek2de1
4 Current relay, Creep start / Normal start
cmek2e03
The current relay is activated when the welding current exceeds 20 A.
Creep start means that the motor runs at 1.9 m/minute until the current relay
operates, after which the speed increases to the set speed. If the current relay does
not operate within one second after starting, the motor speed increases to the set
speed i n any case.
Selector switch SW2 on the circuit board selects Creep Start On/Off. Closing the
switch on to the 0 V rail disengages creep start.