Rev. C Product Specifications of the TM-C100 A-7
TM-C100 Technical Reference Guide
A.4 ASF Specification
Note:
The paper must be flat, without curls or wrinkles (especially at the top edges). Otherwise, the paper may
rub against the nozzles and be soiled.
When printing envelopes, curls or wrinkles may occur because of the sealing method, shape, material and
so on, causing feed and printing errors; therefore prior evaluation is necessary.
In order for cut sheet detection to work properly, do not use paper that has cutouts or holes. However, as
shown in the following figure, holes and cutouts of the "permissible hole and cutout size" in the "hole and
cutout permissible area" are permissible.
Cut sheet hole permissible area
Item Specification
Cut sheet feeder specifications Paper feed type: Friction feed
ASF unit detection: Detection by an optional connector
Cut sheet detection: Detection by the TOF/BOF sensor
Paper specifications Paper type: Plain paper/special paper (special fine paper, special matte
paper)/plain borderless label paper
Paper size: 55 to 135 mm (width) × 85 to 210 mm (length)
Paper thickness: 0.08 to 0.25 mm
Basic weight: 64 to 218 g/m
2
(JIS P8124)
(55 to 188 kg / 1,000 sheets / 788 × 1,091 mm)
Feed specifications Number of sheets set: Combined paper thickness 5.5 mm or less (including
unevenness in the paper)
20 sheets or less (with paper thickness of 0.25 mm)
50 sheets or less (with paper thickness of 0.10 mm)
Mass Approximately 1.9 kg
[Unit: mm, all values are typical]
11 or less
feed direction
3 or more
10 or more
* Hole and cutout outside the "hole and cutout permissible area" are not
hole and cutout
permissible area
8 or less
hole and cutout
ermissible size
