EPSON Imaging Technology Center Page: 44
Revision: 1 (Date: 6/20/00)
6.19 Set Auto Cutting State “ AC” 02H 00H 00H m1
Format: “AC” 02H 00H 00H m1
Parameters:
Parameter m1 is a one byte binary value, and indicates the state as follows:
Set Auto Cutting m1
Auto Cutting Off 00H
Auto Cutting On 01H
Horizontal print page line On 02H
Blank skip eject mode reset
Blank skip eject mode set
40H
41H
Reserved 03H - FFH
Function:
- The default environment roll paper auto cutting state is set.
- If the auto cutting is on, the roll paper is cut automatically at TOF position just
after FF command is executed.
- If the horizontal dot printing is on, it prints horizontal lines at a height of 1 dot
at TOF position just after FF command is executed. (for manual cutting)
- If the sheet is set, or if it is not stopped at TOF position just after FF command
is executed, it doesn’t cut paper / print horizontal line even if it’s On.
- If parameter m1 is out of range, this command is ignored and the existing
setting is maintained.
- This command is only valid in remote mode.
Exception:
- When the banner mode is set, it executes the LD Command, then the FF
Command is processed.
