1.
2.
Getting Started Getting Started
1-11 1-12
Note When installed correctly the ribbon cassette has a sloping position. 1.5.1 Replacing the Ribbon Cassette
7. Move the print head back and forth to settle the ribbon in the correct position.
8. If necessary remove excess ribbon slack by turning the green knob
clockwise.
9. Close the top cover and press [START/STOP] .
Caution: The print head may be very hot immediately after printing!
- Close the top cover and switch the printer ON. Lift the top cover after the
display shows the message READY 4 ELQ to gain access to the ribbon
cassette mountings. The print head will move to the correct position, aligned
with the cut-out in the paper guide plate to facilitate the installation of the
ribbon cassette.
- Now swing the lower part of the ribbon to the back.
In this way the mounting pins loosen from the lower position.
- Then press the upper part of the ribbon to the back. Die upper mounting pins
get free and the ribbon can be taken out.
- To install a new ribbon cassette please see 1.5 Installing the ribbon
cassette (see pages before).
