3
■ Leave enough room around the CX1500 for sufficient ventilation.
■ Do not place the CX1500 near a radiator or heating vent or in direct sunlight.
■ Place the CX1500 on a flat, stable surface that extends beyond its base in all directions. It
will not operate properly if it is tilted or at an angle.
■ Turn off and unplug the CX1500 before cleaning. Clean with a damp cloth only. Do not
spill liquid on it.
■ Always turn the CX1500 off using the P button. Don’t turn off the power using a switch
on a power strip or unplug the CX1500 until the power light is off.
■ Do not block or cover openings in the CX1500 case or insert objects through the slots.
■ Except as specifically explained in your documentation, do not attempt to service the
CX1500 yourself.
■ Unplug the CX1500 and refer servicing to qualified service personnel under the following
conditions: if the power cord or plug is damaged; if liquid has entered the product; if the
product has been dropped or the case damaged; if the product does not operate normally
or exhibits a distinct change in performance. Adjust only those controls that are covered
by the operating instructions.
■ When storing or transporting the CX1500, do not tilt it, stand it on its side, or turn it
upside down; otherwise ink may leak from the cartridge.
■ Before transporting the CX1500, make sure the print head is locked in the far right
position and the ink cartridges are in place.
■ This product includes a lamp component that contains mercury (Hg). Please consult your
state and local regulations regarding disposal or recycling. Do not put it in the trash.
Ink Cartridge Safety Instructions
■ Keep ink cartridges out of the reach of children and do not drink the ink.
■ If ink gets on your hands, wash them thoroughly with soap and water. If ink gets in
your eyes, flush them thoroughly with water.
■ To avoid damaging the printer, never move the print head by hand.
■ Don’t remove the cartridge label, or ink will leak.
■ Don’t remove the green circuit board from the cartridge. Installing a cartridge without a
circuit board can damage the printer. Avoid touching the green circuit board, as this can
damage the ink cartridge.
■ If you remove an ink cartridge for later use, protect the ink supply port on the bottom of
the cartridge from dirt and dust. Place it in a small box, or, if you have the original packaging,
store it in there.
■ Store ink cartridges in the same environment as the printer. Stand cartridges upright; the
label identifying the color should be on top.
■ You cannot print if an ink cartridge is empty. Leave the empty cartridge installed in the
printer until you have obtained a replacement. Otherwise the ink remaining in the print
head nozzles may dry out.
English
