Entering or changing passwords
To specify a User password, you must first specify a Supervisor
password. Follow these steps to enter or change a password:
1. Select Set Supervisor Password and press Enter.
2.
You see a Set Supervisor Password window. Type a
password of up to seven characters and press Enter.
3.
Type the same password a second time and press Enter. You
see a message that your changes have been saved.
4. Press the spacebar. The Supervisor Password option
now displays Enabled.
To set a User password, select the Set User Password
option as you follow the steps above.
Deleting passwords
To delete your passwords, follow these steps:
1. Set the Password on boot option to Disabled.
2.
Delete the User password by pressing Enter for both the
password field and the confirmation field. Don’t type any
characters in these fields.
3.
Then delete the Supervisor password the same way.
delete the User password before you can access the
If you forget your password, see “Password Problems” in
Chapter 7.
2-14 Running SETUP and Installing Drivers
