A SERVICE OF

logo

Open as PDF
next previous
1.
2.
Getting Started
1-13
1.8.1 Replacing the Ribbon Cassette
Caution: The print head may be very hot immediately after printing!
- Close the top cover and switch the printer ON. Lift the top cover after the
display shows the message READY 1 ELQ to gain access to the ribbon
cassette mountings. The print head will move to the correct position, aligned
with the cut-out in the paper guide plate to facilitate the installation of the
ribbon cassette.
- Now swing the lower part of the ribbon to the back.
In this way the mounting pins loosen from the lower position.
- Then press the upper part of the ribbon to the back. The upper mounting
pins get free and the ribbon can be taken out.
Note: To install a new ribbon cassette please see 1.8 Installing the Ribbon
Cassette (see pages before).