30 Installing Components on Your Computer
Macintosh
To assign an IP address and subnet mask to your Macintosh,
follow the steps below.
Note:
You can print using only the AppleTalk protocol and configure the print
server with EpsonNet MacAssist. In Mac OS 8.6 to 9.x, select Ethernet
or Built-in Ethernet on the AppleTalk Control Panel. Then configure
the print server with EpsonNet MacAssist. In OS X, AppleTalk must
be enabled and EPSON AppleTalk must be selected in Print Center.
Mac OS 8.6 to 9.x
1. From the Apple menu, select Control Panel, and then
Appletalk.
2. Set Connect via to Ethernet.
3. Enable AppleTalk and other settings if necessary.
4. Close the dialog box to save any changes.
Now go to “How to Set Up the Print Server” on page 31.
Mac OS X
1. Select Network from System Preferences.
2. Select Built-in Ethernet from the drop-down list.
3. Enable AppleTalk and other settings if necessary.
4. Click Apply Now, then close the dialog box to save any
changes.
Now go to “How to Set Up the Print Server” on page 31.
