Select this option and RS-485 interface will output pan-tile
control signal in Pelco-D format. This format is widely
accepted by most of pan-tilt camera cradles.
You have also input pan-tilt camera cradle’s address code
in ‘Address’ field (number must be between 0~255). This
code must be identical to pan-tilt camera cradle’s address
code.
When the pan-tilt camera cradle does not support Pelco-D
protocol, you can define a protocol’s detail by this function.
Please refer to pan-tilt camera cradle’s user manual to
define the protocol.
- Baud Rate: Select data baud rate of RS-485 interface
that pan-tilt camera cradle will accept. When the
length of RS-485 connection is very long (longer
than 200M), it’s not recommended to use high
speed connection (greater than 2400bps).
- Data Bits: Select data bits of RS-485 connection.
- Parity: Select parity bit: odd, even, or space.
- Stop Bit: Select stop bit: 1 or 2.
- Home/Up/Down/Left/Right: Input the command
string used to move pan-tilt camera cradle to home
or up/down/left/right position. You can click ‘Test’
button to send command string for testing.
- Command 1 ~ 5: You can define extra pan-tilt
camera cradle control strings here by giving it a
name (Command Name) and command string
(Hexadecimal Message). You can also click ‘Test’
button to send command string for testing.
