User's manual OnCourse Navigator | 4
Installation and quick-start guide - 17 -
Mounting and connecting the GPS receiver
Attention: The mounted GPS receiver must not impede the
driver’s attention on traffic.
Connecting the GPS
receiver...
1. Place the GPS receiver horizontally under the windscreen, as
far forwards as possible.
Notice: The reception of GPS-signals may be obstructed by
windscreen heating wires, by a windscreen aerial, or when the
windscreen is metallized. In this case you might use an
external vehicle antenna, which may be ordered from our
support team.
2. Plug the connection cable of the GPS receiver to the
respective socket of the adapter, which connects the Pocket
PC to the power supply.
3. Plug the jack of the adaptor into the socket of the cigarette
lighter.
4. Turn the GPS receiver on.
Establishing a
Bluetooth-connection
4a If you are using a Bluetooth receiver, establish a Bluetooth
connection between the GPS receiver and the Pocket PC.
Notice: For detailed information on how to establish a
Bluetooth connection between your Pocket PC and other
Bluetooth-devices, please refer to the manual of your
Pocket PC.
4b At the first connection via Bluetooth, you will be prompted to
enter a code. Usually this code is 0000.
For information on the correct code, please refer also to the
manual of your Pocket PC or contact the manufacturer of your
device.
