A SERVICE OF

logo

Open as PDF
next previous
OPTICAL RPM SENSOR INSTALLATION
Running WinPEP
Optical RPM Sensor Installation Guide
1-7
SELECTING A NAME
Use the following procedures to set up your Make Run window and make a test run.
In this example we will use a Chevy Corvette owned by Larry Hall.
1 Select the Make.
1a Select Chevy from the file structure.
Figure 1-8: Make Run Window—Select The Make
2 Select the Model. If your model is not present in the file structure, you will need
to add your model to the list.
2a Press Insert to insert a new model.
2b Type the name of your model. You can use small or capital letters.
Example: CORVETTE
2c Click OK to continue.
Figure 1-9: Make Run Window—Select The Model
file structure