INSTALLATION GUIDE
Installation
Version 1 Extemded Carriage Installation Guide
3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INSTALLATION
The extended carriage option increases the maximum wheel base (measured from the
front of the front wheel to the center of the rear wheel) from 84 inches to 102 inches
for testing raked cruisers and drag bikes.
To prevent possible injury, disconnect the battery before performing any dyno
maintenance or installing any optional accessory.
REMOVING THE TIRE CARRIAGE
1 Using a 5/32-inch allen wrench, remove the two button-head screws securing the
carriage screw support bracket and remove the bracket.
Figure 1: Remove the Carriage Screw Support Bracket
2 Unscrew the carriage until it is free from the nut block. Slide the carriage off the
dyno.
3 Using a 1/2-inch wrench, remove the bolts (discard bolts) and washers securing
the nut block and front clamp to the dyno cover and set aside.
4 Using a 1/2-inch wrench, remove the bolts and washers securing the two rear
clamps to the dyno cover and set aside.
Figure 2: Remove the Tire Carriage, Nut Block, and Clamps
carriage screw support bracket
nut block
front clamp
nut block
slide carriage
off dyno
carriage screw
rear clamps
