12
a. Squeeze the air out of the bottle, then insert the fuel tubing into fuel container and draw fuel into
the fuel bottle. The fuel used should be methanol based model engine glow fuel (available at
hobby shops) with 10% to 20% nitro content and 5% to 18% caster/synthetic oil content for
lubrication.
b. Pull up the fuel tubing mounting on the steering pivot. (Green tubing-Transferring fuel to the fuel
tank). Then connect with the nozzle of the fuel tubing of the fuel bottle.
c. Squeeze the fuel bottle to fill fuel tank with glow fuel. When finish, re-mount the green fuel tubing
onto the long set screw on the steering pivot.
Installing optional PRECISION FUELER VALVE : No 1115 (Purchase separately)
a. Take off the upper Lexan body.
b. Use a body reamer to drill a ΓΈ9.5mm hole on the place where is shown on the diagram.
c. Screw the fueler valve onto the upper body shell clockwise stop when there are 1-2mm threads
appearing on the surface of the upper body.
d. Take off the protective cap on the side nozzle, plug the green fuel tubing onto the nozzle, then
use a small nylon strip to fasten the protective cap tight on the lower nozzle. (Note: The green
fuel tubing is the one connecting with the nozzle on the fuel tank)
e. Reinstall the upper body.
f. Use the dual function fuel filter to connect the fuel tubing.
g. Insert the nozzle of the fuel filter into the fueler valve. Squeeze the fuel bottle to fill fuel tank with
glow fuel.
h. You can observe the status of the fueling from the see-through window underneath the lower
body.)
i. When finish, pull the nozzle out of the fueler valve.
14
FUELLING
aa
bb
cc
aa
bb
cc
dd
ee
ff
gg
hh
ii
