24
1-1 Setting the Auto Setup
3
Check the "Power Amp Assign" setting.
• When “Surround Back" is selected, the test tone during Auto Setup will be output from the Surround Back speaker.
• When “ZONE2” or “ZONE3” is selected, change the setting to "ZONE2” or "ZONE3". The test tone during Auto Setup is set so that
it will not be output to ZONE2 or ZONE3 (Another room).
1
Select “Auto Setup” at the Auto Setup / Room EQ
Menu.
(Main unit)
(Remote control unit)
Auto Setup
*AutoSet/RoomEQ
(Main unit)
(Remote control unit)
q Select the Power Amp Assign setting.
w Select “Surround Back”, “ZONE2” or “ZONE3”.
(Main unit)
(Remote control unit)
(Main unit)
(Remote control unit)
4
q Select the “Start”.
(Main unit)
(Remote control unit)
(Main unit)
(Remote control unit)
2
Display the Auto Setup screen.
w Press the Cursor left button.
NOTE:
• When “ZONE2” or “ZONE3” is selected at System
Setup Menu “Power Amp Assign”, surround back
speaker is not displayed as the target of setup in “2-
1.setting the type of speakers. The results is reflected
in “5-1.Power Amp Assign”.
