Denon AVRX4000 Manual

A SERVICE OF

next previous

186

Appendix

TipsPlaybackConnections

Contents

Front panel Display Rear panel IndexRemote

Settings

2 Set the crossover frequency

40Hz / 60Hz / 80Hz (Default) / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz

/ 200Hz / 250Hz

%

•“Crossovers” can be set when the “Subwoofer Mode” (vpage186)

setting is “LFE+Main”, or when you have a speaker that is set to “Small”.

•The default crossover frequency is “80Hz”, which will work best with the

widest variety of speakers. When using very small speakers, however, you

can choose a higher setting based on the speciﬁed frequency response of the

speakers. If the speaker has a speciﬁed frequency response of 120 Hz – 20

kHz (as an example), then choose the 120 Hz crossover frequency.

•For speakers set to “Small”, low frequency content below the crossover

frequency is attenuated to the speakers and the low bass content is then

re-delivered to the subwoofer, or the front (L/R) speakers if they have been

set to Large.

•The speakers that can be set when “Individual” is selected dier depending

on to the “Subwoofer Mode” (vpage186) setting.

•When “LFE” is selected, speakers set to “Small” at “Speaker Conﬁg.”

(vpage182) can be set. If the speakers are set to “Large”, “Full Band” is

displayed and the setting cannot be made.

•When “LFE+Main” is selected, speakers can be set regardless of the

“Speaker Conﬁg.” (vpage182) setting.

Bass

Set subwoofer and LFE signal range playback.

2 Subwoofer Mode

Select low range signals to be reproduced by subwoofer.

LFE (Default) : The low range signal of the channel set to “Small”

speaker size is added to the LFE signal output from the

subwoofer.

LFE+Main : The low range signal of all channels is added to the LFE

signal output from the subwoofer. This is usually the best

setting for most systems.

%

•“Subwoofer Mode” can be set when “Speaker Conﬁg.” – “Subwoofer”

(vpage183) is set to other than “No”.

•Play music or a movie source and select the mode oering the strongest

bass.

•If “Front” and “Center” for “Speaker Conﬁg.” (vpage182) are set to

“Large”, and “Subwoofer Mode” is set to “LFE”, no sound may be output

from the subwoofers, depending on the input signal or selected sound mode.

Select “LFE+Main” if you want the bass signals to always be produced from

the subwoofer.

2 LPF for LFE

Set LFE signal playback range. Set this when you want to change the

playback frequency (low pass ﬁlter point) of the subwoofer.

80Hz / 90Hz / 100Hz / 110Hz / 120Hz (Default) / 150Hz / 200Hz / 250Hz